Products » Rubber Sheets » Potable Water Rubber Sheet

 

 

POTABLE WATER RUBBER SHEET

WQC (Australia) approved EPDM Sheet for using in contact with Drinking Water

 

Water intended for human consumption without imparting any toxic effect is drinking water. Water of sufficient quality to serve as drinking water is termed as potable water whether it is used as such or not. The non-metallic materials can cause changes in water quality when it comes in contact with it. BS 6920 and its modified version AS/NZS 4020:2002 (for Australian and New Zealand requirements) is the method for testing the water quality –i.e, ‘Testing of products for use in contact with drinking water’ and any non-metallic product should comply with these test requirements for getting the approval given by Water Quality Centre(WQC). Zenith PWS has been developed for using in contact with drinking water which has been met all the technical and biological property requirements as tested by following the corresponding Standards.

 

Zenith PWS is a high performance and low specific gravity (1.13) EPDM rubber compound which can be applied for water fitting (supplying) parts e.g., lining, joining, gaskets, membranes, cisterns, O-rings, washers that are used in contact with drinking water.

 
POTABLE RUBBER SHEETS - COMMERCIAL GRADE
Code Specific
Gravity
Hardness
(±5)
Tensile
Strength
Elongation
at break
Compression Set
at 70°C for 22 hrs
Temp.
Range
Colour
gm / cm3 Shore A (min)
kg / cm2
(min)
%
% °C
EP70115 1.13 70 115 350 - -30 to +130 Black
 
Standard Length 10 Mtr 33 Ft 11 Yard
Standard Width 1.2/1.4/1.5 Mtr 4/4.6/4.92 Ft 1.33/1.53/1.64 Yard
 
Note 1). One side or both side smooth or fabric finish can be supplied.
2). Specifications are subject to change without notice.
 

Certifications